Veritas NetBackup™ Appliance Commands Reference Guide

Add or append a hardware administrator's email account for NetBackup to use.

Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.

Delete a hardware administrator's email account for NetBackup to use.

Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.

Define the time span between the alert emails that are sent to the administrator.

Where time is the time between the alert emails that are sent to the administrator. This variable is defined in minutes.

Reset the current email ID to default email ID that is used for the emails that are received from the appliance.

Set a sender email ID that is used for the emails that are received from appliance. Here, Address is the email address of the sender.

View your email or SMTP settings

Add an SMTP server that NetBackup can use.

The Server variable is the host name of the target SMTP server that is used to send emails. The Account option identifies the name of the account that was used or the authentication to the SMTP server. The Password option is the password for authentication to the SMTP server.

Delete the SMTP server that NetBackup uses.

Enable the SMTP server that NetBackup uses.

Add or append a software administrator's email account for NetBackup to use.

Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.

Delete a software administrator's email account for NetBackup to use.

Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.

A test email is sent to the email Addresses configured above. Check if a test email is received in your mail inbox. The email transmission is decided by the network connections, the SMTP settings and the email address settings of your appliance. Follow the prompted error messages to troubleshoot if the test email is not received.