Veritas NetBackup™ Appliance 管理指南

扫描存储设备

1. 登录到 Shell Menu。
2. 通过使用以下命令，转至 Manage > Storage 菜单：

   Main > Manage > Storage

   设备将显示存储菜单中的所有子任务。

3. 输入 Scan 命令以扫描存储设备。

   对于 52xx 设备，将扫描已连接的设备并显示以下输出：

   Storage> Scan
   - [Info] Refreshing the storage devices...
   - [Info] Succeeded.
   
   NOTE: If you run the 'Manage->Storage->Show Disk' command and the device information does not appear in the output, 
   run the 'Manage->Storage->Scan' command to import and refresh the device information. If the device information still does not 
   appear, restart the appliance to refresh the device information.

   对于 5330 设备，将扫描已连接的设备并可能显示以下输出：

   Storage> Scan
   - [Info] Performing sanity check on disks and partitions...
            (5 mins approx)
   - [Info] The scan operation can take up to 15 minutes to complete.
   - [Info] Refreshing the storage devices...
   - [Info] Created 14 new disks (RAID groups) on External Storage.
   - [Info] Succeeded.
   
   - [Info] The new disks are being initialized. The disk initialization 
   happens in the background and may take up to 56 hours depending on the 
   system load. You can continue to use the appliance during this time. 
   However, if one or more of the new disks are used by partitions during 
   the disk initialization process, the performance of backup and restore 
   operations on the specific disks degrades by up to 30%.
   
   NOTE: If you run the 'Manage->Storage->Show Disk' command and the device 
   information does not appear in the output, run the 'Manage->Storage->Scan'
   to import and refresh the device information. If the device information 
   still does not appear, restart the appliance to refresh the device 
   information.