Search <book_title>...

Veritas NetBackup™ Appliance 管理指南

Last Published: 2017-11-30

Product(s): Appliances (3.1 (5340), 3.1 (5330), 3.1 (5240), 3.1 (5230), 3.1 (5220))

从设备 Shell 菜单创建设备检查点

使用以下过程从设备 Shell 菜单创建用户控制的检查点。

注意:

如果已存在一个用户控制的检查点，您即将创建的检查点会替换这个现有检查点。在任何指定时间只能存在一个用户控制的检查点。

从设备 Shell 菜单创建新检查点

以管理员身份登录到设备并打开设备 Shell 菜单。

输入以下命令

Main_Menu > Support > Checkpoint Create

将开始以下交互过程。shell 菜单会通知您是否存在现有检查点，然后才能创建新的检查点。在下例中，不存在现有检查点。

Creating an Appliance Checkpoint allows the user to easily
 rollback the entire system back to a point-in-time to undo any
 misconfiguration or system failure that might have occurred. An 
Appliance Checkpoint captures the following components:
        1) Appliance Operating System
        2) Appliance Software
        3) NetBackup Software
        4) Networking Configuration
        5) Any previously applied patches
        6) Backup data is not reverted

There are no checkpoints in the system.
There is no user checkpoint. Please continue to create a user checkpoint
>> Would you like to proceed? (yes/no) yes

输入 Yes 继续创建新的检查点。
输入对检查点的说明。这是一个可选字段。

输入 Yes 开始检查点创建过程。

- [Info] Deleting checkpoint: USER
- [Info] CREATING USER CHECKPOINT
- [Info] Creating checkpoint. This operation can take 10 to 
         15 minutes.

     Please wait...

- [Info] Appliance Checkpoint creation was successful

注意:

一旦开始检查点创建过程，您仍然可以使用 Web Console。

请参见检查点创建状态。