Veritas NetBackup™ Flex Scale Best Practices and Troubleshooting Guide

Last Published:
Product(s): Appliances (3.1)
Platform: NetBackup Flex Scale OS
  1. Introduction
    1.  
      Scope and intended audience
    2.  
      About NetBackup Flex Scale
    3.  
      About NetBackup Flex Scale nodes
  2. Configuration requirements
    1.  
      Physical environment
    2.  
      NetBackup Flex Scale configuration requirements
    3.  
      Firewall and network ports requirements
    4.  
      Considerations for using IPv6 addresses
  3. Best practices
    1.  
      Management network connectivity
    2.  
      Private network connectivity
    3.  
      Configuring AutoSupport for the appliance
    4.  
      Necessary software
  4. NetBackup Flex Scale tuning and sizing
    1.  
      Assigning media servers to a storage server
    2.  
      NetBackup Flex Scale tuning
  5. Troubleshooting NetBackup Flex Scale
    1.  
      NetBackup Flex Scale logs
    2.  
      Services management
    3.  
      Audit logs
    4. Collecting logs for cluster nodes
      1.  
        Uploading logs to Veritas Support
      2.  
        Downloading logs
    5.  
      Error messages displayed during the pre-upgrade check
    6. Troubleshooting NetBackup Flex Scale issues
      1.  
        If cluster configuration fails (for example because an IP address that was already in use is specified) and you try to reconfigure the cluster, the UI displays an error but the configuration process continues to run
      2.  
        Validation error while adding VMware credentials to NetBackup
      3.  
        NetBackup Web UI incorrectly displays some NetBackup Flex Scale processes as failed
      4.  
        Unable to create BMR Shared Resource Tree (SRT) on NetBackup Flex Scale Appliance
      5.  
        NetBackup configuration files are not persistent across operations that require restarting the system
      6.  
        Connection timeout errors during patch installs, upgrades, and rollback operations
      7.  
        Initial configuration wizard displays a driver node not selected error
      8.  
        Initial configuration wizard displays a license error after successfully configuring the cluster

Validation error while adding VMware credentials to NetBackup

For protecting VMware virtual machines, you add the login credentials of the VMware vCenter Server, VMware ESXi server, or VMware vCloud Director server to the NetBackup configuration. While adding the access credentials, you may see the following credential validation error in the NetBackup Java Console UI.

VMware credential validation failed. Cannot connect on socket (Status 25)

Cause

This issue occurs when the NetBackup Flex Scale appliance cluster is configured using a pure IPv6 address configuration while the VMware system uses IPv4 addresses. NetBackup Flex Scale appliance does not support communication between a pure IPv6 and a pure IPv4 address configuration.

Solution

To resolve this issue, the VMware system must be configured to use either a pure IPv6 address or a mixed mode dual stack IP address configuration.