Veritas NetBackup™ Flex Scale Best Practices and Troubleshooting Guide

Last Published:
Product(s): Appliances (3.1)
Platform: NetBackup Flex Scale OS
  1. Introduction
    1.  
      Scope and intended audience
    2.  
      About NetBackup Flex Scale
    3.  
      About NetBackup Flex Scale nodes
  2. Configuration requirements
    1.  
      Physical environment
    2.  
      NetBackup Flex Scale configuration requirements
    3.  
      Firewall and network ports requirements
    4.  
      Considerations for using IPv6 addresses
  3. Best practices
    1.  
      Management network connectivity
    2.  
      Private network connectivity
    3.  
      Configuring AutoSupport for the appliance
    4.  
      Necessary software
  4. NetBackup Flex Scale tuning and sizing
    1.  
      Assigning media servers to a storage server
    2.  
      NetBackup Flex Scale tuning
  5. Troubleshooting NetBackup Flex Scale
    1.  
      NetBackup Flex Scale logs
    2.  
      Services management
    3.  
      Audit logs
    4. Collecting logs for cluster nodes
      1.  
        Uploading logs to Veritas Support
      2.  
        Downloading logs
    5.  
      Error messages displayed during the pre-upgrade check
    6. Troubleshooting NetBackup Flex Scale issues
      1.  
        If cluster configuration fails (for example because an IP address that was already in use is specified) and you try to reconfigure the cluster, the UI displays an error but the configuration process continues to run
      2.  
        Validation error while adding VMware credentials to NetBackup
      3.  
        NetBackup Web UI incorrectly displays some NetBackup Flex Scale processes as failed
      4.  
        Unable to create BMR Shared Resource Tree (SRT) on NetBackup Flex Scale Appliance
      5.  
        NetBackup configuration files are not persistent across operations that require restarting the system
      6.  
        Connection timeout errors during patch installs, upgrades, and rollback operations
      7.  
        Initial configuration wizard displays a driver node not selected error
      8.  
        Initial configuration wizard displays a license error after successfully configuring the cluster

NetBackup Web UI incorrectly displays some NetBackup Flex Scale processes as failed

The Activity Monitor > Daemons tab in the NetBackup Web UI displays the status of the NetBackup processes running in your NetBackup environment. Sometimes, the status of the NetBackup Flex Scale processes such as spad and spoold may appear as failed even though the processes themselves are running fine in the cluster.

Solution:

There is no solution at the moment. It is safe to ignore the incorrect status displayed in the NetBackup Web UI.