Veritas NetBackup™ Flex Scale Installation and Configuration Guide

Last Published:
Product(s): Appliances (2.1)
Platform: NetBackup Flex Scale OS
  1. Preparing for NetBackup Flex Scale deployment
    1.  
      Deployment overview
    2.  
      Deployment options
    3.  
      NetBackup Flex Scale configuration requirements
    4.  
      Firewall and network ports requirements
    5.  
      Considerations for using IPv6 addresses
  2. Configuring NetBackup Flex Scale
    1.  
      Assigning a public IP address to network adapter eth1 of a node
    2.  
      NetBackup Flex Scale configuration methods
    3.  
      Configuring NetBackup Flex Scale using the setup wizard
    4. Configuring NetBackup Flex Scale using a configuration file
      1.  
        YML configuration file for deploying NetBackup primary and media servers
      2.  
        YML configuration file for deploying media servers
    5.  
      Changing the maintenance user account password
  3. Troubleshooting NetBackup Flex Scale deployment
    1.  
      NetBackup Flex Scale logs
    2.  
      Connection timeout errors during patch installs, upgrades, and rollback operations
    3.  
      Initial configuration wizard displays a driver node not selected error
    4.  
      Initial configuration wizard displays a license error after successfully configuring the cluster
  4. NetBackup Flex Scale upgrades and patch management
    1. About NetBackup Flex Scale upgrades and EEB
      1.  
        Pre-upgrade steps
      2.  
        Considerations for upgrade when disaster recovery is configured
    2.  
      Performing a patch upgrade using GUI
    3.  
      Installing EEBs using GUI
    4.  
      Performing a patch upgrade using REST APIs
    5.  
      Installing EEBs using REST APIs
    6.  
      About rolling upgrade
  5. Removing NetBackup Flex Scale
    1. About disk erasure
      1.  
        Configuring data erasure
      2.  
        Viewing the data erasure status
      3.  
        Aborting data erasure
    2.  
      About NetBackup Flex Scale node factory reset
    3.  
      Performing a factory reset on a node
  6. Appendix A. Installing NetBackup Flex Scale
    1.  
      About NetBackup Flex Scale software installation
    2.  
      Enabling remote IPMI connections
    3.  
      Setting up the RAID configuration on the nodes
    4.  
      Configuring the BIOS settings on the nodes
    5.  
      Downloading the product installer ISO
    6.  
      Mounting the ISO file on the nodes
    7.  
      Installing NetBackup Flex Scale using the ISO
    8.  
      Installing Emergency Engineering Binaries (EEBs)

About NetBackup Flex Scale node factory reset

The purpose of a factory reset is to return a node to a clean unconfigured default factory state. A factory reset discards all the data from the node, including storage and networking configuration and reverts the node to the factory image. However, you can choose to retain the network configuration, if required, before you initiate a factory reset. Additionally, you can also choose whether or not to restart the node immediately after the reset completes. However, a node restart is required for the factory reset process changes to take effect on the node.

During the factory reset process, the following components are reset:

  • Appliance software

  • NetBackup software

  • Storage configuration and backup data

  • (optional) Networking configuration

You can perform a factory reset using the factory reset command from the system command prompt.

Note:

You cannot factory reset a node if the node is in the cluster, disk erasure is in progress, or the lockdown mode is set to compliance or enterprise.