Veritas NetBackup™ Flex Scale Installation and Configuration Guide

Last Published:
Product(s): Appliances (2.1)
Platform: NetBackup Flex Scale OS
  1. Preparing for NetBackup Flex Scale deployment
    1.  
      Deployment overview
    2.  
      Deployment options
    3.  
      NetBackup Flex Scale configuration requirements
    4.  
      Firewall and network ports requirements
    5.  
      Considerations for using IPv6 addresses
  2. Configuring NetBackup Flex Scale
    1.  
      Assigning a public IP address to network adapter eth1 of a node
    2.  
      NetBackup Flex Scale configuration methods
    3.  
      Configuring NetBackup Flex Scale using the setup wizard
    4. Configuring NetBackup Flex Scale using a configuration file
      1.  
        YML configuration file for deploying NetBackup primary and media servers
      2.  
        YML configuration file for deploying media servers
    5.  
      Changing the maintenance user account password
  3. Troubleshooting NetBackup Flex Scale deployment
    1.  
      NetBackup Flex Scale logs
    2.  
      Connection timeout errors during patch installs, upgrades, and rollback operations
    3.  
      Initial configuration wizard displays a driver node not selected error
    4.  
      Initial configuration wizard displays a license error after successfully configuring the cluster
  4. NetBackup Flex Scale upgrades and patch management
    1. About NetBackup Flex Scale upgrades and EEB
      1.  
        Pre-upgrade steps
      2.  
        Considerations for upgrade when disaster recovery is configured
    2.  
      Performing a patch upgrade using GUI
    3.  
      Installing EEBs using GUI
    4.  
      Performing a patch upgrade using REST APIs
    5.  
      Installing EEBs using REST APIs
    6.  
      About rolling upgrade
  5. Removing NetBackup Flex Scale
    1. About disk erasure
      1.  
        Configuring data erasure
      2.  
        Viewing the data erasure status
      3.  
        Aborting data erasure
    2.  
      About NetBackup Flex Scale node factory reset
    3.  
      Performing a factory reset on a node
  6. Appendix A. Installing NetBackup Flex Scale
    1.  
      About NetBackup Flex Scale software installation
    2.  
      Enabling remote IPMI connections
    3.  
      Setting up the RAID configuration on the nodes
    4.  
      Configuring the BIOS settings on the nodes
    5.  
      Downloading the product installer ISO
    6.  
      Mounting the ISO file on the nodes
    7.  
      Installing NetBackup Flex Scale using the ISO
    8.  
      Installing Emergency Engineering Binaries (EEBs)

About NetBackup Flex Scale software installation

Your NetBackup Flex Scale appliance comes pre-installed with an operating system and the NetBackup Flex Scale software. You do not have to install anything on the raw nodes after you take them out of the box. Once you have assembled the nodes and placed the appliance in your data center environment, you verify the configuration prerequisites and begin with the cluster configuration.

See Configuring NetBackup Flex Scale using the setup wizard.

The installation instructions provided here are intended to serve only as a reference. They are useful in case you decide to wipe the appliance clean and start a fresh deployment.

If you plan to leverage your own hardware instead of the out of the box appliance, ensure that you contact Veritas Support to generate and install device certificates on your nodes.

Refer to the following:

See Enabling remote IPMI connections.

See Setting up the RAID configuration on the nodes.

See Configuring the BIOS settings on the nodes.

See Downloading the product installer ISO.

See Mounting the ISO file on the nodes.

See Installing NetBackup Flex Scale using the ISO.

See Installing Emergency Engineering Binaries (EEBs).