Veritas Access Appliance Command Reference Guide
- Overview
- Appendix A. Main > Appliance
- Appendix B. Main > Manage > Cluster
- Appendix C. Main > Manage > Software
- Appendix D. Main > Manage > Storage
- Appendix E. Main > Network
- Network > Configure
- Network > Date
- Network > DNS
- Network > Gateway
- Network > Hosts
- Network > IPv4
- Network > IPv6
- Network > SetProperty
- Network > Show
- Network > TimeZone
- Network > NetStat
- Network > NTPServer
- Network > Unconfigure
- Network > VLAN
- Network > TraceRoute
- Network > Ping
- Network > Hostname
- Network > Proxy
- Appendix F. Main > Monitor
- Appendix G. Main > Settings
- Appendix H. Main > Support
Name
Main > Manage > Cluster > Configure — Configure the Access cluster on the appliance.
SYNOPSIS
Configure
DESCRIPTION
Use this command to configure the Access cluster on the appliance from the current node.
Note the following before you run the command:
The Access cluster configuration is only allowed to run from one node. Make sure that the Access cluster configuration process is not already ongoing on the current node or other nodes.
Make sure that you have the node management IP addresses of the appliance nodes for clustering.
Make sure that you have reserved enough IP addresses for use as the physical and the virtual IP addresses of the Access cluster. At least four continuous IP addresses must be reserved for each type.
Do not run the Configure on the current node in the following scenarios:
When the cluster configuration process is already running on another node of the Access appliance.
When the node has been factory reset without resetting the storage, and the Access cluster remains on the other node.
When the node is an unconfigured node that is used to replace a faulty node in an Access cluster.
OPTIONS
- Configure
Use the command to configure the Access cluster on the appliance.