Veritas NetBackup™ 5330 Appliance Product Description
- NetBackup 5330 Appliance overview
- About the NetBackup 5330 Appliance
- NetBackup 5330 Appliance system features
- Serial number locations
- NetBackup 5330 Appliance compute node disk drive configurations
- NetBackup 5330 Appliance compute node control panel information
- About the NetBackup 5330 Appliance compute node rear panel
- NetBackup 5330 Appliance compute node PCIe slot I/O configuration options
- NetBackup 5330 Appliance compute node Ethernet port configurations
- Dual-port 10 Gb Ethernet card with SFP+ transceiver ports
- Dual-port 8 Gb Fibre Channel Host Bus Adapter (FC HBA) specifications
- About NetBackup 5330 Appliance storage shelves
- Best practices for rack installation
- NetBackup 5330 Appliance cables
- Appendix A. Technical specifications, standards, and compliance information
- Index
NetBackup 5330 Appliance compute node disk drive LED descriptions
Each disk drive module contains two LEDs on the left-hand side of each module.
The LEDs appear as follows:
The LED on the top is solid amber when a disk drive fault occurs. This LED is not lit when there are no disk drive faults.
The LED on the bottom is solid green when power is supplied to the disk drive. This LED flashes green when the disk drive is active.
Note that the disk drive modules that do not contain disk drives also have LEDs. Although there is no drive activity going on, some colored lights may still be seen through the disk modules.
Table: Disk drive module LED descriptions
LED color | Condition | Description/Behavior |
|---|---|---|
Amber | Off | No access and no fault |
Amber | On | A hard drive fault has occurred |
Amber | Blinking | A RAID rebuild is in progress (1 Hz), Identify (2 Hz) |
Green | Power on with no drive activity | LED stays on |
Green | Power on with drive activity | LED blinks off when processing a command |
Green | Power on and drive spun down | LED stays off |
Green | Power on and drive spinning up | LED blinks |