Veritas NetBackup™ Flex Scale Installation and Configuration Guide

Last Published:
Product(s): Appliances (3.1)
Platform: NetBackup Flex Scale OS
  1. Preparing for NetBackup Flex Scale deployment
    1.  
      Deployment overview
    2.  
      Deployment options
  2. Configuring NetBackup Flex Scale
    1.  
      Assigning a public IP address to network adapter eth1 of a node
    2.  
      NetBackup Flex Scale configuration methods
    3.  
      Configuring NetBackup Flex Scale using the setup wizard
    4. Configuring NetBackup Flex Scale using a configuration file
      1.  
        YML configuration file for NetBackup primary and media server deployment
      2.  
        YML configuration file for media server only deployment
  3. NetBackup Flex Scale upgrades and patch management
    1.  
      About NetBackup Flex Scale upgrades and EEBs
    2.  
      About rolling upgrade
    3.  
      About parallel upgrade and supported upgrade paths
    4. About the pre-upgrade check
      1.  
        Error messages displayed during the pre-upgrade check
    5. Upgrading NetBackup Flex Scale
      1. Performing pre-upgrade tasks
        1.  
          Considerations for upgrade when disaster recovery is configured
      2.  
        Performing an upgrade using GUI
      3.  
        Post upgrade tasks
      4.  
        Performing an upgrade using REST APIs
    6.  
      Installing EEBs using GUI
    7.  
      Installing EEBs using REST APIs
    8.  
      Updating the firmware in NetBackup Flex Scale clusters
  4. Removing NetBackup Flex Scale
    1. About disk erasure
      1.  
        Configuring data erasure
      2.  
        Viewing the data erasure status
      3.  
        Aborting data erasure
    2.  
      About NetBackup Flex Scale node factory reset
    3.  
      Performing a factory reset on a node
  5. Appendix A. Installing NetBackup Flex Scale using a downloaded ISO file
    1.  
      About NetBackup Flex Scale software installation
    2.  
      Enabling remote IPMI connections
    3.  
      Setting up the RAID configuration on the nodes
    4.  
      Configuring the BIOS settings on the nodes
    5.  
      Downloading the product installer ISO
    6.  
      Mounting the ISO file on the nodes
    7.  
      Installing NetBackup Flex Scale using the ISO
    8.  
      Installing hardware vendor packages
    9.  
      Installing Emergency Engineering Binaries (EEBs)

Aborting data erasure

You can abort a running data erasure operation at any time. After you abort the operation, the data on the affected disks is corrupted. The Last Erasure Status for the affected disks shows Aborted. You must configure data erasure again for all the disks if you want to complete the erasure. The data erasure operation starts anew on all the disks the next time.

To abort the data erasure

  1. Log on to the NetBackup Flex Scale Appliance Shell Menu.
  2. From the system view, run the following command:

    system storage erase-disks abort

  3. Enter Yes to abort the data erasure operation.