Veritas InfoScale™ Operations Manager 7.3.1 Add-ons User's Guide

To verify that the NaviSecCLI can communicate with CLARiiON arrays

1. Enter the following command at the command prompt of CLARiiON management host:

   naviseccli -h arrayIPAddress -user userName -password 
   passWord -scope userScope networkadmin -get

   Where:

   arrayIPAddress is the IP address, the fully qualified domain name, or the name of one of the storage processors in the array.

   userName is a valid user name for the account in the array.

   passWord is the password for userName.

   userScope is the scope of the user that you specified when you created the account in the array. It can be Local, Global, or LDAP.

2. Review the information that displays:

   • If NaviSecCLI can communicate with the arrays, the following information is displayed:

     Storage Processor:                  SP B
     Storage Processor Network Name:     cx500-2spb
     Storage Processor IP Address:       10.100.18.18
     Storage Processor Subnet Mask:      255.255.248.0
     Storage Processor Gateway Address: 10.100.16.1

     If this command succeeds, Storage Insight Add-on uses the credentials to communicate with the array.

   • If NaviSecCLI cannot communicate with the array, the following information is displayed:

     Broken Pipe
     
     Valid IP Address with Feature not installed:
     naviseccli -h cx500a -user admin -password password -scope 0 
     networkadmin -get
     Management Server - Feature software is not installed or the 
     command may have been typed incorrectly
     usage:
       metalun
       migrate
       connection
       mirror
       snapview
       analyzer