Enterprise Vault™ Setting up File System Archiving (FSA)
- About this guide
- About File System Archiving
- About FSA shortcut files
- Steps to configure File System Archiving
- Adding a Windows file server to File System Archiving
- About archiving from Windows Server 2012 or later file servers
- Permissions and privileges required by the Vault Service account on Windows file servers
- Adding a NetApp filer to File System Archiving
- Adding a NetApp C-Mode Vserver to File System Archiving
- Adding a Celerra/VNX device to File System Archiving
- Adding a Dell EMC Unity device to File System Archiving
- Configuring FSA with clustered file servers
- Troubleshooting the configuration of FSA with clustered file servers
- Installing the FSA Agent
- Defining volume and folder policies
- About selecting the shortcut type for an FSA policy
- About FSA policy archiving rules
- Configuring the deletion of archived files on placeholder deletion
- Configuring target volumes, target folders, and archive points
- About adding target volumes, target folders, and archive points for FSA
- About managing archive points
- Archive point properties
- Effects of modifying, moving, or deleting folders
- About deleting target folders, volumes, and file servers
- Configuring pass-through recall for placeholder shortcuts
- Configuring and managing retention folders
- Configuring and running FSA tasks
- Using Run Now to process FSA targets manually
- Configuring file system filtering
- Managing the file servers
- PowerShell cmdlets for File System Archiving
- Appendix A. Permissions and privileges required for the Vault Service account on Windows file servers
- Permissions required by the Vault Service account for the FSA Agent
Configuring a file server's firewall for FSA
Read this section if the Windows file server that you want to configure as an FSA target is protected by a firewall.
You must perform some configuration steps to allow Enterprise Vault to communicate successfully with the file server through the firewall. Unless you perform the required configuration steps, the following problems will occur:
Installation of the FSA Agent from the Administration Console fails.
The File System Archiving task fails. You may receive the following messages from DTrace or in the File System Archiving task report:
The RPC server is unavailable. (Exception from HRESULT: 0x800706BA)
Error making file a placeholder file. Catastrophic failure (Exception from HRESULT: 0x8000FFFF)
For information on how to configure a firewall for FSA, see the following technical note on the Veritas Support website: