Veritas NetBackup™ Flex Scale Installation and Configuration Guide
About NetBackup Flex Scale node factory reset
The purpose of a factory reset is to return a node to a clean unconfigured default factory state. A factory reset discards all the data from the node, including storage and networking configuration and reverts the node to the factory image. However, you can choose to retain the network configuration, if required, before you initiate a factory reset. Additionally, you can also choose whether or not to restart the node immediately after the reset completes. However, a node restart is required for the factory reset process changes to take effect on the node.
Note:
If the cluster is running with the minimum number of nodes (three healthy nodes), then at this stage the cluster can tolerate only one disk failure on the remaining nodes and still remain operational.
During the factory reset process, the following components are reset:
Appliance software
NetBackup software
Storage configuration and backup data
(optional) Networking configuration
You can perform a factory reset using the factory reset command from the system command prompt.
More Information