Veritas™ 5350 Appliance Product Description Guide
- About the Veritas 5350 Appliance
- About the Veritas 5350 Appliance
- Features and components of the appliance
- Locating the appliance serial number
- Compute node disk drive configurations
- About the compute node front panel USB port
- About the compute node control panel
- About the compute node rear panel
- Appliance network interface card port assignments
- Veritas 5350 Appliance I/O configuration options
- Available PCIe-based I/O configurations
- Total I/O on-board and PCIe ports
- Available I/O configurations by slot for Veritas 5350 Appliance installations
- RSP3GD016J storage adapter
- Mellanox ConnectX-4 Lx EN MCX4121A-ACAT Ethernet card
- QLE2692 dual-port 16Gb Fibre Channel host bus adapter
- Intel Storage Adapter RS3P4GF016J
- Broadcom P225p 10/25Gb PCIe Ethernet card
- About the Veritas 5U84 Storage Shelves
- About Veritas 5350 Appliance storage shelves
- About the 5U84 Primary Storage Shelf and 5U84 Expansion Storage Shelf rear components
- Veritas 5350 Appliance and 5U84 Storage Shelf cables
- Appendix A. Technical specifications, Environmental/Protocol standards, and Compliance standards
- Veritas 5350 compute node technical specifications
- Veritas 5U84 Storage Shelf technical specifications
- Environmental specifications
- Protocol standards
- Regulatory, compliance, and certification information
- Product regulatory compliance
- Country approvals
- Product safety compliance
- Product EMC Compliance - Class A Compliance
- Product environmental compliance
About the compute node rear panel
The rear panel of the appliance compute node has several access ports and other features.
The rear panel of the Veritas 5350 Appliance contains three PCIe riser card assemblies. PCIe riser card assemblies 1 and 2 each support three standard PCIe cards, while PCIe riser card assembly 3 supports two low profile PCIe cards.
Table: Veritas 5350 Appliance rear panel features and connectors
Number | Function |
|---|---|
1 | Power Supply 1 and Power Supply 2 - Dual, redundant, and hot-swappable power supply modules |
2 | DB-15 VGA monitor connector |
3 | Serial port - Serial connection for Veritas Technical Support use only |
4 | Three stacked USB 3.0 Type A serial ports for general use |
5 | IPMI port - An external RJ45 port used for appliance remote management purposes |
6 | OCP 1Gbs Ports |
7 | PCIe Riser # 1 |
8 | PCIe Riser # 2 |
9 | PCIe Riser # 3 |
Veritas appliances may include grounding studs in case your lab environment has such a requirement. The studs are located on the rear panel of the appliance. You can use standard grounding practices to connect grounding wires to the studs.
The serial number is located on a vertical bar on the rear panel of the appliance.
The ports on the rear panel are color-coded for easy identification.
