APTARE IT Analytics Data Collector Installation Guide for Replication Manager
- Pre-Installation setup for NetApp (Replication)
- Installing the Data Collector software
- Introduction
- Installing the WMI Proxy service (Windows host resources only)
- Testing WMI connectivity
- Installing Data Collector software: From the internet
- Installing Data Collector software: No internet available from the Data Collector server
- Installing Data Collector software on Windows portal platform
- Installing Data Collector software on Linux portal platform
- Validating Data Collection
- Uninstalling the Data Collector
- Manually starting the Data Collector
- Appendix A. Firewall configuration: Default ports
Introduction
This section includes the instructions for installing the Data Collector software on the Data Collector Server. In addition, if you are collecting data from host resources, you may need to install the WMI Proxy Service. The WMI Proxy Service is installed by default, as part of the storage array Data Collector installation on a Windows server.
In addition to the GUI version, the installer supports a console (command line) interface for Linux systems that do not have X-Windows installed. You will be directed to the console interface instructions, if appropriate.
When the APTARE IT Analytics system collects data from any vendor subsystem, the collection process expects name/value pairs to be in US English, and requires the installation to be done by an Administrator with a US English locale. The server's language version can be non-US English.
Note:
Log in as a Local Administrator to have the necessary permissions for this installation.