Please enter search query.
Search <book_title>...
NetBackup™ Plug-in for VMware vSphere Client (HTML5) Guide
Last Published:
2022-03-28
Product(s):
NetBackup & Alta Data Protection (10.0)
- Introduction and notes
- Installing the NetBackup plug-in for vSphere Client (HTML5)
- Requirements for the NetBackup plug-in for vSphere Client (HTML5)
- Using consistent vCenter naming with the NetBackup plug-in for vSphere Client (HTML5)
- vCenter privileges for managing NetBackup plug-in installation
- Notes on using the vSphere Client (HTML5) plug-in in a VMware Platform Services Controller (PSC) environment
- Installing the NetBackup plug-in for vSphere Client (HTML5)
- Register Plug-in when no other Plug-in (either Local or current) is installed
- Register Plug-in when no Local Plug-in registered, and one or more Plug-ins's are already registered
- Register plug-in when local plug-in already registered but no other Plug-in registered
- Register Plug-in when local Plug-in already registered, and one or more Plug-in's already registered
- VIRTUALIZATION_HOSTS_SECURE_CONNECT_ENABLED for servers and clients
- Uninstalling the NetBackup plug-in for vSphere Client (HTML5)
- Uninstalling the NetBackup Local plug-in for vSphere Client (HTML5)
- Plug-in Configurations
- Log in to the Plug-in
- Excluding virtual disks from the backup
- Monitoring backup status
- Restoring virtual machines
- Troubleshooting
- A NetBackup primary server is not available in the primary server list of the login screen
- The NetBackup plug-in for vSphere Client (HTML5) does not find any backup images in the listed events
- Mismatch in vCenter server name (uppercase vs. lowercase letters) causes the VMware connectivity test to fail
- Instant recovery operation is not complete due to NFS mount limit exceed
- Instant recovery option is disabled for the selected recovery point
- The vCenter server names are not available for search
- Virtual machine display name conflicts are not shown before the pre-recovery check
- Reasons for failure of pre-recovery checks
- Too much time taken to populate the list of NetBackup primary servers
- The NetBackup plug-in is not shown in the vSphere Client (HTML5) interface even after registration
- The NetBackup plug-in is not shown in the vSphere Client (HTML5) interface after vCenter upgrade from older versions to vCenter 7.0 or later
- Unregistering the plug-in may result in total uninstallation of the plug-in
- Recovery wizard errors
- No recovery point found error
- Limitations
- Appendix A. Instant recovery events and best practices
Perform Instant Recovery of virtual machines
- On the Recovery Wizard > Virtual Machine Selection dialog, select the virtual machine to restore. See Virtual Machine Selection screen.
- On the Recovery Points tab:
Select the appropriate date and time range and click SEARCH RECOVERY POINTS.
From the Recovery Options, select Instant virtual machine recovery and click Next.
Note:
Instant virtual machine recovery option is enabled if and only if the recovery point is ready for instant recovery.
Note:
You can restore the virtual machine to its original location or to a different location.
- From the Recovery Targettab, fill the following details:
Display Name: Name of the VM
ESXi server or cluster
Resource pool or vApp
Datastore or Datastore cluster
Click NEXT.
Note:
Click CHANGE in front of receptive field to change the default value.
- On the Recovery Options tab, select all the applicable options. See Instant Recovery: Recovery Options.
- On the Pre-Recovery Check tab, review all the parameters. Click RUN PRE-RECOVERY CHECK.
- Once the pre-recovery check is successful, click START RECOVERY.
- Click OK for Recovery Job Initiated dialog.