Veritas Access Appliance 8.4 Initial Configuration Guide

Last Published:
Product(s): Appliances (8.4)
Platform: Veritas 3350,Veritas 3340,Veritas 3360
  1. Getting to know the Access Appliance
    1.  
      About the Veritas Access Appliance
    2. About the Access Appliance administration interfaces
      1.  
        Using the Access Appliance shell menu
    3. About licensing the Access Appliance
      1.  
        About subscription licensing
    4.  
      Where to find the documentation
  2. Preparing to configure the appliance
    1.  
      Initial configuration requirements
    2.  
      About obtaining IP addresses for Veritas Access
    3.  
      Network and firewall requirements
    4.  
      About network connections for the appliance
  3. Configuring the appliance for the first time
    1. How to configure the Access Appliance for the first time
      1.  
        Configuring the Access cluster on the appliance
  4. Getting started with the Veritas Access GUI
    1.  
      Accessing the Veritas Access web interface
  5. Network connection management
    1. Configuring network address settings on the appliance nodes
      1.  
        Deleting network settings on appliance nodes
      2.  
        About NIC1 (eth0) port usage on the appliance nodes
      3.  
        About IPv4-IPv6-based network support on the Access Appliance
    2. Configuring VLAN settings on the appliance nodes
      1.  
        Viewing VLAN settings
      2.  
        Deleting a VLAN
    3. About the Veritas Remote Management Console
      1.  
        Configuring the IPMI port on an appliance node
      2.  
        Managing IPMI users on an appliance node
      3.  
        Resetting the IPMI on an appliance node
  6. Resetting the appliance to factory settings
    1.  
      About appliance factory reset
    2.  
      Performing factory reset for cluster nodes
  7. Appliance security
    1.  
      About Access Appliance security
    2. About Access appliance user account privileges
      1. Access appliance admin password specifications
        1.  
          Password encryption and handling on the Access appliance
    3.  
      About forced password changes
    4.  
      Changing the Maintenance user account password
    5. About the Access Appliance intrusion detection system
      1.  
        Reviewing SDCS events on the Access Appliance
      2.  
        Auditing the SDCS logs on an Access Appliance
      3.  
        About SDCS event type codes and severity codes on an Access appliance node
      4.  
        Changing the SDCS log retention settings on an Access Appliance node
    6.  
      About the Access Appliance intrusion prevention system
    7. About Access appliance operating system security
      1.  
        Vulnerability scanning of the Access Appliance
      2.  
        Disabled service accounts on the Access appliance
    8.  
      About data security on the Access appliance
    9.  
      About data integrity on the Access appliance
    10. Recommended IPMI settings on the Access appliance
      1.  
        Replacing the default IPMI SSL certificate on the Access appliance

About NIC1 (eth0) port usage on the appliance nodes

By default, NIC1 (eth0) is set to IP address 192.168.229.233. This private network address is reserved to provide a direct connection from a laptop to perform the initial configuration of the IPMI interface. The eth0 IP address cannot be changed. The eth0 is only used for the initial configuration of the IPMI interface or in situations where eth1 and IPMI are not reachable.