Search <book_title>...

Storage Foundation for Oracle® RAC 7.4.1 Configuration and Upgrade Guide - Solaris

Last Published: 2019-06-18

Product(s): InfoScale & Storage Foundation (7.4.1)

Platform: Solaris

Verifying LLT

Use the lltstat command to verify that links are active for LLT. If LLT is configured correctly, this command shows all the nodes in the cluster. The command also returns information about the links for LLT for the node on which you typed the command.

Refer to the lltstat(1M) manual page for more information.

To verify LLT

Log in as superuser on the node sys1.
Run the lltstat command on the node sys1 to view the status of LLT.
```
lltstat -n
```
The output on sys1 resembles:
```
    LLT node information:
        Node             State           Links
        *0 sys1          OPEN           2
         1 sys2          OPEN           2
```
Each node has two links and each node is in the OPEN state. The asterisk (*) denotes the node on which you typed the command.
If LLT does not operate, the command does not return any LLT links information: If only one network is connected, the command returns the following LLT statistics information:
```
LLT node information:
    Node                 State    Links
   * 0 sys1            OPEN        2
     1 sys2            OPEN        2
     2 sys5            OPEN        1
```
Log in as superuser on the node sys2.

Run the lltstat command on the node sys2 to view the status of LLT.

lltstat -n

The output on sys2 resembles:

    LLT node information:
        Node             State           Links
         0 sys1          OPEN           2
        *1 sys2          OPEN           2

To view additional information about LLT, run the lltstat -nvv command on each node.
For example, run the following command on the node sys1 in a two-node cluster:
```
lltstat -nvv active
```
The output on sys1 resembles the following:
- For Solaris SPARC:
```
    Node          State      Link    Status      Address
    *0 sys1      OPEN
                             net1 UP     08:00:20:93:0E:34
                             net2 UP     08:00:20:93:0E:38
    1 sys2       OPEN
                             net1 UP     08:00:20:8F:D1:F2
                             net2 DOWN
```
The command reports the status on the two active nodes in the cluster, sys1 and sys2.
For each correctly configured node, the information must show the following:
- A state of OPEN
- A status for each link of UP
- An address for each link
However, the output in the example shows different details for the node sys2. The private network connection is possibly broken or the information in the /etc/llttab file may be incorrect.

To obtain information about the ports open for LLT, type lltstat -p on any node.

For example, type lltstat -p on the node sys1 in a two-node cluster:

lltstat -p

The output resembles:

    LLT port information:
      Port  Usage       Cookie
      0     gab          0x0
            opens:       0 2 3 4 5 6 7 8 9 10 11 ... 60 61 62 63
            connects:    0 1 
      7     gab          0x7
            opens:       0 2 3 4 5 6 7 8 9 10 11 ... 60 61 62 63
            connects:    0 1 
      31    gab          0x1F
            opens:       0 2 3 4 5 6 7 8 9 10 11 ... 60 61 62 63
            connects:    0 1