Veritas Access 3360 Appliance Product Description
- About the Access 3360 Appliance
- About the Veritas Access 3360 Appliance
- Features and components of the appliance
- Locating the appliance serial number
- About 3360 compute node drive configurations
- About the compute node front panel USB port
- About the compute node control panel
- About the compute node rear panel
- Standard 3360 Appliance PCIe-based I/O configuration
- About the Veritas 5U84 Storage Shelves
- About Veritas Access 3360 Appliance storage shelves
- About the 5U84 Primary Storage Shelf and 5U84 Expansion Storage Shelf rear components
- Access 3360 Appliance and 5U84 Storage Shelf cables
- Appendix A. Technical specifications, Environmental/Protocol standards, and Compliance standards
- Index
About the compute node rear panel
The rear panel of the appliance compute node has several access ports and other features, which are displayed in the following figures.
Table: Compute node rear panel features and connectors
Number | Function |
|---|---|
1,10 | Power Supply 1 and Power Supply 2 - Dual, redundant, and hot-swappable power supply modules |
2 | DB-15 VGA monitor connector |
3 | IPMI port - An external RJ45 port used for appliance remote management purposes |
4 | Serial port - Serial connection for Veritas Technical Support use only |
5 | eth0/NIC1 A 10/1 Gbps port copper connector that is reserved for use during the initial configuration of the 3360 Appliance Note: Veritas does not support forming a NIC bond using eth0/NIC1 with other eth/NIC ports. |
6 | eth1/NIC2 A 10/1 Gbps port copper connector |
7 | eth2/NIC3 A 10/1 Gbps port copper connector For a two-node configuration, the eth2 ports on each of the 3360 Appliance compute nodes attach to each other using straight through or cross-over cables. For example, eth2 on first compute node connects to eth2 of the second compute node. For a single-node 3360 configuration, connect eth2 to eth3 on the same compute node. |
8 | eth3/NIC4 A 10/1 Gbps port copper connector For a two-node configuration, the eth3 ports on each of the 3360 Appliance compute nodes attach to each other using straight through or cross-over cables. For example, eth3 on first compute node connects to eth3 of the second compute node. For a single-node 3360 configuration, connect eth2 to eth3 on the same compute node. |
9 | Three stacked USB 3.0 Type A serial ports for general use |
11 | PCIe riser assembly 1 |
12 | PCIe riser assembly 2 |
13 | PCIe riser assembly 3 * (empty) |
* 3360 Appliance compute nodes do not contain PCIe riser cards in PCI riser assembly 3. | |
Veritas appliances may include grounding studs in case your lab environment has such a requirement. The studs are located on the rear panel of the appliance. You can use standard grounding practices to connect grounding wires to the studs.
The ports on the rear panel are color-coded for easy identification.
