NetBackup™ Snapshot Manager for Data Center Administrator's Guide

To recover NetBackup Snapshot Manager for Data Center

1. Copy the existing NetBackup Snapshot Manager for Data Center backup to the new NetBackup Snapshot Manager for Data Center server and extract it to the NetBackup Snapshot Manager for Data Center installation directory.

   In the following example, because /cloudpoint was backed up, the command creates a new /cloudpoint directory.

   # tar -zxf cloudpoint_dr.tar.gz -C /cloudpoint/

2. Download or copy the NetBackup Snapshot Manager for Data Center installer binary to the new server.
3. Install NetBackup Snapshot Manager for Data Center.

   Use the following command:

   (For Docker)

   # sudo docker run -it --rm -u 0
   -v /cloudpoint:/cloudpoint
   -v /var/run/docker.sock:/var/run/docker.sock
   veritas/flexsnap-deploy:10.x.x.x.xxxx install

   (For Podman)

   # sudo podman run -it --rm -u 0
   -v /cloudpoint:/cloudpoint
   -v /var/run/podman.sock:/var/run/podman.sock
   veritas/flexsnap-deploy:10.x.x.x.xxxx install

   Here, 10.x.x.x.xxxx represents the NetBackup Snapshot Manager for Data Center version. Replace it as per your currently installed product version.

   Note:

   This is a single command. Ensure that you enter the command without any line breaks.

4. When the installation completes, you can resume working with NetBackup Snapshot Manager for Data Center using your existing credentials.