NetBackup IT Analytics Data Collector Installation Guide for Backup Manager

To install Data Collector software on Linux:

1. Login as root on the server where NetBackup IT Analytics Data Collector has to be installed.
2. Ensure the following rpms are present on the system:

   On SuSe: libXrender1 and libXtst6

   On other Linux systems: libXtst and libXrender

   Since the above rpms are essential for proper functioning of the Data Collector, you can run the below commands on the Data Collector server to check whether the rpms are present.

   On SuSe: rpm -q libXrender1 libXtst6

   On other Linux systems: rpm -q libXtst libXrender

   The output of the above commands will print the rpms that are present on the system.

3. Go to the downloads section under Support on www.veritas.com and click the relevant download link.
4. Mount the ISO image that you downloaded.

   mkdir /mnt/diska
   mount -o loop <itanalytics_datacollector_linux_xxxxx.iso> /mnt/diska
   

   Substitute the name of the ISO image downloaded have downloaded.

5. Start the installer:

   cd /
   /mnt/diska/dc_installer.sh
   

6. Review the End User License Agreement (EULA) and enter accept to agree.
7. Provide the install location. The default location is /opt/aptare . Accepting the default paths is recommended.

   If you specify a custom location, aptare directory is created at the specified location.

8. The installer will prompt for the Data Collector Name. This is the name that you used during the configuration of Data collector in Portal UI. The Data Collector will use this value for authentication purposes.
9. The installer requests for the following details.

   • Data Collector Name: Specify the Data Collector name that you used during its configuration on the NetBackup IT Analytics Portal. Data Collector uses this for authentication. If you are installing on a non-English OS, the Data Collector name must be in English.

   • Data Collector Passcode: Specify the Data Collector passcode that you used for the Data Collector name during its configuration on the NetBackup IT Analytics Portal. This passcode is encrypted prior to saving it to the portal database and is never visible in any part of the application. If the password contains a special character, make sure it is one of the following OS-specific supported character:

     • Linux: !@#%^*

     • Windows: !@#$%^&*()

     If the special character in the passcode is not supported on the OS, you must update the Data Collector passcode on the portal.

   • Data Receiver URL: Enter the URL that the Data Collector will use to communicate with the portal server. The format must be http://itanalyticsagent.yourdomain.com.

     Make sure you enter the URL with the prefix itanalyticsagent and not itanalyticsportal.

   • Data Collector Key File Path: Enter the location of the downloaded collector key file for encryption.

     If the existing key file is not available, regenerate it and download a new key file from the portal and enter its file path.

   • Web Proxy (HTTP) settings can be configured. Enter y to configure proxy. The installer prompts for:

     • HTTP Proxy IP Address: Enter the hostname or IP address and a port number.

     • HTTP Proxy Port: Enter the proxy port number for HTTP proxy.

     • Proxy UserId and password: Enter the credentials for the proxy server.

     • No Proxy For: Enter the host names or IP addresses separated by commas that will not be routed through the proxy.