NetBackup™ Web UI Cloud Administrator's Guide
- Introducing the NetBackup web user interface
- Managing cloud assets
- About protecting cloud assets
- Limitations and considerations
- Registering the CloudPoint server with NetBackup
- Adding configurations for a cloud provider
- Editing or disabling configurations for a cloud provider
- Configuring cloud asset discovery interval
- Recovering a cloud asset to its original location
- Recovering a cloud asset to an alternate location
- Troubleshooting cloud workload protection issues
Registering the CloudPoint server with NetBackup
You can register the CloudPoint server using one of the following ways:
Using the NetBackup Administration Console.
Using the -tpconfig command.
tpconfig -add -cloudpoint_server cloudpoint_server_name -cloudpoint_server_user_id user_ID [-cloud_provider cloud_provider_value] [-requiredport IP_port_number]
See the NetBackup Commands Reference Guide.
When you configure a CloudPoint server with NetBackup:
You can associate multiple cloud providers with a CloudPoint server, but you cannot associate multiple CloudPoint servers with a cloud vendor.
You can associate a specific NetBackup media server with the CloudPoint server.
Media server association is supported only using the tpconfig command line.
tpconfig -update -cloudpoint_server cloudpoint_server_name -add_media_server media_server
To associate multiple media servers, you must run the command multiple times. The media server must be on version 8.1.2 or later. If you do not associate a media server, the NetBackup master server is used.