Veritas NetBackup™ 5240 Appliance Product Description
- About the NetBackup 5240 Appliance
- NetBackup 5240 Appliance overview
- Features and components of the NetBackup 5240 Appliance
- NetBackup 5240 Appliance front panel disk drive configurations
- NetBackup 5240 Appliance front panel USB port
- NetBackup 5240 Appliance control panel
- NetBackup 5240 Appliance rear panel
- NetBackup 5240 Appliance I/O configuration options
- NetBackup 5240 Appliance total I/O on-board and PCIe ports
- Customizable I/O configurations by slot for existing NetBackup 5240 Appliance installations
- QLE2692 dual-port 16Gb Fibre Channel host bus adapter
- Intel X710-DA2 dual-port 10Gb Ethernet card
- Dual-port 10 Gb Ethernet card with SFP+ transceiver ports
- QLE8442 dual-port 10Gb Ethernet/iSCSI capable card with SFP+ modules
- QLE2562 dual-port 8Gb Fibre Channel host bus adapter with SFP+ modules
- Quad-port 1Gb Ethernet card with RJ45 connectors
- SAS tape-out adapter
- NetBackup 5240 Appliance Network Interface Port locations and speeds
- NetBackup 5240 Appliance I/O configuration options
- About the Veritas 2U12 49TB Storage Shelf
- NetBackup 5240 Appliance and Veritas 2U12 49TB Storage Shelf cables
- Appendix A. Technical specifications and compliance standards
- NetBackup 5240 Appliance and Veritas 2U12 49TB Storage Shelf technical specifications
- Environmental specifications
- Protocol standards
- Regulatory, compliance, and certification information
FCC Verification Statement (USA)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If the equipment is not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to a radio or a television reception (can be determined by turning the equipment off and on), the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit other than the one to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the grantee of this device can void the user's authority to operate the equipment. The customer is responsible to ensure compliance of the modified product. Only peripherals (computer input or output devices, terminals, printers, etc.) that comply with FCC Class A or B limits may be attached to this product. Operation with noncompliant peripherals is likely to result in interference to radio and TV reception. All cables that are used to connect to peripherals must be shielded and grounded. Operation with regulatory and compliance information 65 Electromagnetic compatibility notices the cables that are connected to peripherals that are not shielded and grounded may result in interference to radio and TV reception.