Veritas NetBackup™ 5240 Appliance Product Description
- About the NetBackup 5240 Appliance
- NetBackup 5240 Appliance front panel disk drive configurations
- NetBackup 5240 Appliance control panel
- NetBackup 5240 Appliance rear panel
- NetBackup 5240 Appliance I/O configuration options
- NetBackup 5240 Appliance I/O configuration options
- About the Veritas 2U12 49TB Storage Shelf
- NetBackup 5240 Appliance and Veritas 2U12 49TB Storage Shelf cables
- Appendix A. Technical specifications and compliance standards
- Regulatory, compliance, and certification information
NetBackup 5240 Appliance rear panel
The rear panel of the appliance has several access ports and other features, which are displayed in the following figures.
Table: NetBackup 5240 Appliance rear panel features and connectors
Number | Function |
---|---|
1,2 | Power Supply 1 and Power Supply 2 - Dual, redundant, and hot-swappable power supply modules |
3 | eth4/NIC 5 A 1-GbE/10-GbE copper connectors for general use |
4 | eth5/NIC 6 A 1-GbE/10-GbE copper connectors for general use |
5 | DB-15 VGA monitor connector |
6 | Three stacked USB 2.0/3.0 Type A serial ports for general use |
7 | IPMI port - An external RJ45 port used for appliance remote management purposes |
8 | eth0/NIC 1 A 1-GbE port copper connector that is reserved for use during the initial configuration of the appliance. After completing the initial configuration, you can connect NIC1 (eth0) to an administrative network that does not provide any backup data transfer For more information, see the Veritas NetBackup™ 52xx Appliance Initial Configuration Guide - Release 3.1.1. Note: Veritas does not support forming a NIC bond using eth0/NIC1 with other eth/NIC ports. |
9 | eth1/NIC 2 A 1-GbE port copper connector for general use |
10 | eth2/NIC 3 A 1-GbE port copper connector for general use |
11 | eth3/NIC 4 A 1-GbE port copper connector for general use |
12, 13 | The NetBackup 5240 Appliance add-in cards are available in multiple configurations. Several configurations include at least one Fibre Channel host bus adapter card for VMware, optimized deduplication over Fibre Channel, or tape library connectivity. In some configurations the Fibre Channel host bus adapter cards are installed into some of the PCIe slots. If the cards are installed in slots 5 and 6, the configuration supports Fibre Transport Media Server (FTMS) mode. Port 1 of each card is configured by default as Target, while port 2 is configured by default as Initiator. If you want, you can configure port 2 on both cards as Target, and you can configure port 1 on both cards as Initiator. Note: Only configurations D and E support FTMS. Note: You cannot bond copper 1 Gb/10 Gb Ethernet ports that are installed in the appliance chassis with PCIe-based 10 Gb Ethernet Fibre Channel ports. |
NetBackup 5240 Appliances may include grounding studs in case your lab environment has such a requirement. The studs are located on the rear panel of the appliance. You can use standard grounding practices to connect grounding wires to the studs.
The serial number is located on a vertical bar on the rear panel of the appliance.
The ports on the rear panel are color-coded for easy identification.