NetBackup™ Snapshot Manager for Data Center Administrator's Guide

About the NetBackup Snapshot Manager for Data Center fluentd configuration file

Fluentd uses a configuration file that defines the source of the log messages, the set of rules and filters to use for selecting the logs, and the target destinations for delivering those log messages.

The fluentd daemon running on the NetBackup Snapshot Manager for Data Center host is responsible for sending the NetBackup Snapshot Manager for Data Center logs to various destinations. These target destinations, along with the other details such as input data sources and required fluentd parameters are defined in the plug-in configuration file. For NetBackup Snapshot Manager for Data Center, these plug-in configurations are stored in a fluentd configuration file that is located at /cloudpoint/fluent/fluent.conf on the NetBackup Snapshot Manager for Data Center host. The fluentd daemon reads the output plug-in definition from this configuration file to determine where to send the NetBackup Snapshot Manager for Data Center log messages.

The following output plug-in definition is added to the configuration file by default:

STDOUT: This is used to send the NetBackup Snapshot Manager for Data Center log messages to /cloudpoint/logs/flexsnap.log.

The plug-in is defined as follows:

# Send to fluentd docker logs
<store>
@type stdout
</store>

Additionally, the NetBackup Snapshot Manager for Data Center fluentd configuration file includes plug-in definitions for the following destinations:

These plug-in definitions are provided as a template and are commented out in the file. To configure an actual Splunk, or ElasticSearch target, you can uncomment these definitions and replace the parameter values as required.